基于超精密切削的柱面微透镜阵列模具制备工艺研究
CSTR:
作者:
作者单位:

(1. 中国科学院光电技术研究所, 成都 610209;2. 中国科学院大学, 北京 100049)

作者简介:

青建宏(1997-),男,四川遂宁人,硕士研究生,主要研究方向为微纳米压印技术;

通讯作者:

中图分类号:

基金项目:


Research on Manufacturing Process of Cylindrical Microlens Array Mold Based on Ultra-precision Cutting
Author:
Affiliation:

(1. Institute of Optics and Electronics, Chinese Academy of Sciences, Chengdu 610209, CHN;2. University of Chinese Academy of Sciences, Beijing 100049, CHN)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    文章对柱面微透镜阵列纳米压印中用到的精密模具的制作过程开展了仿真分析和实验研究。超精密切削技术是制作精密压印模具的有效手段之一。基于Johnson-Cook本构模型,采用有限元分析方法模拟了超精密切削过程中切削参数与切削力之间的关系,获得了优选的切削参数。实验结果表明,采用优选后的切削参数进行柱面微透镜阵列模具切削能够获得良好的切削效果。切削后模具的面形精度RMS值达到19nm,表面粗糙度Sq达到4nm。

    Abstract:

    The production process of precision molds used in cylindrical microlens nanoimprint was simulated, and ultra-precision cutting technology is one of the effective means for processing precision imprinting mold. Based on the Johnson-Cook constitutive model, the finite element analysis method was applied to simulate the relationship between the cutting parameters and the cutting force during the ultra-precision cutting process, and the preferred cutting parameters were obtained. Experimental results show that the cylindrical microlens array mold can obtain good cutting effect using the preferred cutting parameters. The surface precision RMS value and the surface roughness Sq of the mold after cutting reaches 19 and 4nm, respectively.

    参考文献
    相似文献
    引证文献
引用本文

青建宏,李云.基于超精密切削的柱面微透镜阵列模具制备工艺研究[J].半导体光电,2021,42(5):716-720. QING Jianhong, LI Yun. Research on Manufacturing Process of Cylindrical Microlens Array Mold Based on Ultra-precision Cutting[J].,2021,42(5):716-720.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2021-07-17
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2021-11-02
  • 出版日期:
文章二维码