Abstract:This article proposes an Al2O3 passive junction PIN detector. Based on traditional PIN detectors, a 10nm Al2O3 thin film is deposited at the PN junction on the front and the high-low junction on the back of the device. After TCAD simulation, it is found that the detector has lower leakage current and electron current density at the protective ring compared to traditional detectors, and can generate sufficient response current to high-energy particle ray incidence. Then, the chip fabrication steps of two detectors were designed to prepare the device, and the minority carrier lifetime of the thin film was characterized, as well as the dark state IV testing and 241Am elemental energy spectrum testing of the device. The results showed that compared to traditional PIN detectors, the minority carrier lifetime of the substrate of the Al2O3 passive junction PIN detector after depositing Al2O3 thin film is increased to 1061us, the leakage current is reduced to 5nA, and the energy resolution is improved to 521eV.