Abstract:Cadmium zinc telluride (CdZnTe) is the most crucial room-temperature semiconductor nuclear radiation detector material. The substitution of some Te with Se in the CdZnTe lattice to obtain cadmium zinc telluride selenide (CdZnTeSe) will lead to an increase in the composition of ionic bonds in the lattice, which will improve the hardness of the crystal, reduce the concentration of Cd vacancies and Te inclusions defects, and enhance the quality of the material. In order to obtain CdZnTeSe crystals suitable for the preparation of nuclear radiation detectors, in this work, the growth of CdZnTeSe crystals under Te-rich conditions was investigated by the vertical Bridgman method, and Cd0.9Zn0.1Te0.97Se0.03 single-crystal ingots with a diameter of 21 mm and a length of more than 70 mm were successfully prepared. The obtained Cd0.9Zn0.1Te0.97Se0.03 crystals have an X-ray diffraction wobble half-peak width of 0.104° in the (1 1 0) plane, whereas the size of the Te intercalation phase is <5 μm, which indicates that the crystals have good crystallinity. The energy band gap and IR transmittance of Cd0.9Zn0.1Te0.97Se0.03 ingot tails are lower than that of the head and middle of the ingot, which can be attributed to the decrease of crystallinity in the subsequent growth stages of the crystals due to the insufficient release of latent heat during the growth of Cd0.9Zn0.1Te0.97Se0.03 by the vertical Bridgman method. Moreover, the electrical performance indexes of the head and middle of the CdZnTeSe ingots meet the requirements for preparing room-temperature radiation detectors.