高温退火对低温硫化生长的ZnS薄膜性能的影响
CSTR:
作者:
作者单位:

(1. 武汉科技大学 冶金工业过程系统科学湖北省重点实验室, 武汉 430081;2. 中国科学院高能物理研究所, 北京 100049)

作者简介:

王朋杰(1996-),男,山西省临汾市人,硕士,主要研究方向为Ⅱ-Ⅵ族半导体薄膜;

通讯作者:

中图分类号:

TN304

基金项目:

国家自然科学基金项目(11975173);武汉科技大学冶金工业过程系统科学湖北省重点实验室开放基金项目(Y201713).通信作者:张仁刚


Effect of High-temperature Annealing on the Properties of ZnS Thin Films Grown by Low-temperature Sulfurization
Author:
Affiliation:

(1. Hubei Province Key Laboratory of Systems Science in Metallurgical Process, Wuhan University of Science and Technology, Wuhan 430081, CHN;2. Institute of High Energy Physics, Chinese Academy of Sciences, Beijing 100049, CHN)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    首先,采用磁控溅射法在石英玻璃衬底上沉积Zn薄膜;然后,通过低温硫化工艺制备出ZnS薄膜;其次,在500~800℃高温和氩气气氛中对样品进行1h退火处理;最后,使用XRD,SEM,EDS和紫外-可见分光光度计等仪器,研究了退火温度对所得ZnS薄膜性能的影响。研究结果表明,通过低温硫化工艺制备出的ZnS薄膜为六方结构,在高温退火后,其晶粒尺寸变大,在可见光范围透光率高达约80%,带隙为3.59~3.63eV。随着退火温度的升高,ZnS薄膜的晶粒尺寸从20nm增加至28nm,S/Zn原子比降低,表面形貌也发生变化,其中,当退火温度为500℃时,所得ZnS薄膜的质量较好,而当退火温度大于等于600℃时,ZnS薄膜中会出现硫杂质相。

    Abstract:

    Zn thin films were deposited on quartz glass substrates using the magnetron sputtering method, whereby ZnS thin films were formed via low-temperature sulfurization annealing. Finally, annealing of ZnS films was conducted at high temperatures of 500~800℃ in an argon atmosphere for 1 hour. The effect of annealing temperature on the properties of the ZnS films thus obtained was investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectrocscopy (EDS), and ultraviolet (UV) visible spectrophotometer. The results show that the ZnS thin film prepared by low-temperature sulfurization has a hexagonal structure. After high-temperature annealing, the grain size on ZnS films increased, and their transmittance in the visible light range was approximately 80% within bandgaps of 3.59~3.63eV. With further increases in annealing temperature, the grain size of ZnS thin films increased from 20nm to 28nm, the S/Zn atomic ratio decreased, and the surface morphology also changed. Sulfur impurities appeared in the ZnS films after high-temperature annealing at temperatures ≥600℃. The optimal high-temperature annealing temperature was 500℃, and the resulting ZnS film exhibited good film quality.

    参考文献
    相似文献
    引证文献
引用本文

王朋杰,张仁刚,张超,张鹏,曹兴忠,王宝义.高温退火对低温硫化生长的ZnS薄膜性能的影响[J].半导体光电,2024,45(6):904-909. WANG Pengjie, ZHANG Rengang, ZHANG Chao, ZHANG Peng, CAO Xingzhong, WANG Baoyi. Effect of High-temperature Annealing on the Properties of ZnS Thin Films Grown by Low-temperature Sulfurization[J].,2024,45(6):904-909.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2024-08-24
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2025-02-20
  • 出版日期:
文章二维码