Abstract:In this paper, in order to solve the problem of loosening and creep of bolts in long-term service, a bolt stress test method based on Fiber Bragg Grating (FBG) sensing is proposed. Firstly, the femtosecond laser processing technology was used to fabricate FBG through the fiber coating, and an erbium-doped fiber laser with linear cavity structure was designed based on the fiber grating to achieve laser output with high signal-to-noise ratio. Secondly, bolt gaskets made of stainless steel and aluminum of different sizes were designed and prepared, and their mechanical characteristics were simulated and analyzed. Next, the FBG was embedded in the stainless steel and aluminum gasket grooves and combined with the bolts to build a stress test system, and by applying stress to the surface of the gasket, the FBG was deformed accordingly, resulting in the drift of the laser wavelength. In the experiment, 0~10N.m stress was applied to the bolt strain test system of stainless steel and aluminum gasket with groove depth of 1mm and 1.5mm, respectively, and with the increase of stress, the laser wavelength showed a red shift, and the center wavelength of the stainless steel and aluminum washer sensor with a groove depth of 1mm moved by 41 and 61.8pm, respectively, and the sensitivity was 4.05 and 6.13pm/(N.m), respectively. The 1.5 mm groove depth stainless steel and aluminum gasket sensors have wavelengths drifting 141.7 and 180.5 pm, respectively, sensitivities of 14.12 and 18 pm/(N.m), respectively, and linearity of 0.99.