基于FPGA内部资源的高精度数字延时系统设计
DOI:
CSTR:
作者:
作者单位:

1.武汉大学电子信息学院;2.北京控制与电子技术研究所

作者简介:

通讯作者:

中图分类号:

基金项目:

湖北省重点研发计划项目(2022BID016);航天系统装备预先研究项目


Design of high-precision digital delay system based on FPGA internal resources
Author:
Affiliation:

1.College of Electronic Information, Wuhan University, Wuhan;2.Beijing Institute of Control and Electronic Technology, Beijing

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对星载激光测高系统回波模拟设备中长距离、高精度延时的需求,提出一种基于现场可编程门阵列(FPGA)内部集成特殊延迟线的数字式脉冲延时发生器(Digital Delay Generator,DDG)架构。自测量补偿型DDG由“内插延时线 + 三级粗、细时间延迟电路”组成。基于CARRY4组成的内插延时线精确测量外部触发信号到达时刻和FPGA内部时钟采集沿之间的时间差,从而精准确定时间延时的起点。再依次经过粗时间计数、粗相位调节和细相位调节三级时间延时策略,实现了基于触发信号起始时刻的长时间尺度下的高精度延时。DDG设计中包括抖动自测量和校准方法,适用于内部和外部触发,其设计资源完全依赖于FPGA片内基础资源,确保了设计的广泛适应性。实验结果表明,当使用频率精度为±0.5ppm的振荡器时,在补偿后的外部触发模式下,时间最小延时步进可达37.5±7.5ps,在2ms延时下输出抖动优于270ps(RMSE 31ps)。

    Abstract:

    Aiming at the demand for long-distance and high-precision delay in the echo simulation equipment of the satellite-mounted laser altimetry system, a digital pulse delay generator (DDG) architecture based on the internal integration of special delay lines in the field-programmable gate array (FPGA) is proposed. Self-measurement compensation type DDG consists of “interpolation delay line + three levels of coarse and fine time delay circuit”. Based on the CARRY4 interpolated delay line to accurately measure the time difference between the arrival of the external trigger signal and the FPGA internal clock acquisition edge, so as to accurately determine the starting point of the time delay. Then, through the three-level time delay strategy of coarse time counting, coarse phase adjustment and fine phase adjustment in sequence, high precision delay is realized under the long time scale based on the starting moment of the trigger signal. The DDG design includes jitter self-measurement and calibration methods, which are applicable to both internal and external triggering, and its design resources are completely reliant on the FPGA on-chip base resources to ensure the wide adaptability of the design. Experimental results show that when using an oscillator with a frequency accuracy of ±0.5 ppm, the time-minimum delay step is up to 37.5 ± 7.5ps in compensated externally triggered mode, and the output jitter is better than 270ps (RMSE 31ps) at a 2-ms delay.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2024-12-30
  • 最后修改日期:2025-02-27
  • 录用日期:2025-02-28
  • 在线发布日期:
  • 出版日期:
文章二维码