基于 FPGA内部资源的高精度数字延时系统设计
CSTR:
作者:
作者单位:

(1.武汉大学电子信息学院,武汉 430072;2.北京控制与电子技术研究所,北京 100045;3.武汉量子技术研究院,武汉 430206)

作者简介:

冯伟(1996-),男,硕士研究生,主要研究方向为基于 FPGA的精密延时、高精度测时;李松(1965-),女,博士,教授,博士生导师,主要从事卫星激光遥感与设备方面的研究。

通讯作者:

中图分类号:

TN791

基金项目:

湖北省重点研发计划项目(2022BID016);航天系统装备预先研究项目 .


Design of A High-precision Digital Delay System Based on Field-programmable Gate-array Internal Resources
Author:
Affiliation:

(1. College of Electronic Information,Wuhan University,Wuhan 430072,CHN;2. Beijing Institute of Control and Electronic Technology,Beijing 100045,CHN;3. Wuhan Institute of Quantum Technology,Wuhan 430206,CHN)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    面向星载激光测高系统回波模拟设备对长距离传输、高精度延时的需求,提出一种基于现场可编程门阵列(FPGA)片上特殊延迟资源的全数字式脉冲延时发生器(DDG)架构。该自测量补偿型 DDG采用 “内插延时线 +三级粗、细时间延迟电路 ”的复合结构设计,通过多级协同控制实现从亚纳秒到毫秒量级的高精度延时覆盖。系统核心采用基于 CARRY4进位链的内插延时线模块,可精确测量外部触发信号到达时刻与 FPGA时钟采集沿之间的时间差,为延时起点提供精确基准。延时控制采用分级递进:首级粗时间计数通过时钟周期累加实现毫秒级延时;次级粗相位调节完成时钟周期内整数倍延迟单位的补偿;末级细相位调节依托可编程延迟单元实现精细调节。DDG设计中包括抖动自测量和校准方法,适用于内部和外部触发,其设计资源完全依赖于 FPGA片内基础资源,确保了设计的广泛适应性。实验结果表明,当使用频率精度为 ±0. 5 ppm的振荡器时,在补偿后的外部触发模式下,时间最小延时步进可达(37. 5±7. 5)ps,在 2 ms延时下输出抖动优于 270 ps(均方根误差为 31 ps),验证了该架构在星载激光测距系统中的工程适用性。

    Abstract:

    To meet the demand for long-distance and high-precision delay in the echo simulation equipment of satellite-mounted laser altimetry systems,a digital pulse delay generator(DDG)architecture,based on the internal integration of special delay lines in field-programmable gate arrays(FPGAs), is proposed. A self-measurement compensation-type DDG consists of “interpolation delay line + three levels of coarse and fine time-delay circuits. ”The CARRY4 interpolated delay line is leveraged to accurately measure the time difference between the arrival of the external trigger signal and the FPGA internal-clock-acquisition edge and thus locate the starting point of the time delay with high accuracy. Then,the three-level time delay scheme of coarse time counting is applied for sequential coarse and fine phase adjustments—this approach enables the realization of high-precision delay on long-time scales based on the starting moment of the trigger signal. The DDG design incorporates jitter self-measurement and calibration methods,which are applicable to both internal and external triggering. In addition, its design resources rely on FPGA on-chip-based resources,ensuring wide adaptability of the design. Experimental results show that when an oscillator with a frequency accuracy of ±0. 5 ppm is used,a minimum-time-delaystepofupto 37.5± 7.5ps is obtained in the compensated externally triggered mode,and fora 2-ms delay,the output jitter is better than 270 ps(the root mean square error is 31 ps).

    参考文献
    相似文献
    引证文献
引用本文

冯伟,于文博,栾超,向雨琰,李松.基于 FPGA内部资源的高精度数字延时系统设计[J].半导体光电,2025,46(2):318-326. FENG Wei, YU Wenbo, LUAN ChaO, XIANG Yuyan, LI Song. Design of A High-precision Digital Delay System Based on Field-programmable Gate-array Internal Resources[J].,2025,46(2):318-326.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2024-12-30
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2025-06-26
  • 出版日期:
文章二维码