Abstract:Monocrystalline silicon, as a basic material for semiconductor devices, has characteristics such as high hardness, high brittleness, and low fracture toughness, posing significant challenges in micro-nano processing. Laser machining is widely used for the fabrication of microstructures in monocrystalline silicon, but it is accompanied by notable thermal damage. To address this issue, a novel method for through-groove machining of silicon wafers based on laser-electrochemical hybrid processing is proposed. This method leverages the photo-thermal coupling effect of lasers and the property of monocrystalline silicon"s conductivity increasing with temperature, achieving a combination of laser etching and electrochemical dissolution, thereby effectively improving machining quality. The mechanism of laser-induced electrochemical machining was elucidated, and a corresponding experimental scheme was designed. Comparative experimental results demonstrated that the laser-electrochemical hybrid processing surpassed traditional laser dry cutting methods in terms of surface quality. Further investigation into the effect of applied voltage on the machining surface quality revealed that at a voltage of 40 V, the surface roughness was significantly reduced to 310 nm, achieving the optimal machining outcome.