基于光频转换实现室温中波碲镉汞探测器大动态范围读出
DOI:
CSTR:
作者:
作者单位:

1.上海大学;2.中国科学院上海技术物理研究所

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重点基础研究发展计划(973计划)


Large Dynamic Range Readout for Room-Temperature Mid-Wave HgCdTe Detectors via light-to-Frequency Converter
Author:
Affiliation:

Shanghai Institute of Technical Physics Chinese Academy of Sciences

Fund Project:

The National Basic Research Program of China (973 Program)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    室温工作的中波红外碲镉汞探测器由于阻抗低、背景电流大等问题,导致信号读出时信噪比和动态范围都难以提升,限制该探测器室温下的应用效果。本文设计了一种光频转换电路结构,该电路通过低失调运放稳定探测器工作状态,再对探测器的光电流进行电流-电压-电流-频率的转换,将较大的光电流压缩至符合电流频率输入级的范围(0 ~ 4.3 μA),同时该电路也能对探测器暗电流和背景电流进行抑制。测试结果表明电路在与探测器结合后动态范围可达93 dB,电路功耗仅为27.3 mW,实现了中波红外碲镉汞探测器的室温大动态范围读出。

    Abstract:

    Mid-wave infrared (MWIR) HgCdTe detectors operating at room temperature face challenges in enhancing signal-to-noise ratio (SNR) and dynamic range (DR) during signal readout due to their low impedance and high background current, which limit their practical applications under non-cooled conditions. This paper presents a light-to-frequency converter (LFC) circuit architecture designed to address these limitations. The proposed circuit stabilizes the detector’s operating state using a low-offset operational amplifier and employs a current-to-voltage-to-current-to-frequency conversion process to compress the large photocurrent into a range suitable for the current-frequency input stage (0 to 4.3 μA). Additionally, the circuit effectively suppresses dark current and background current from the detector. Experimental results demonstrate that the integrated system achieves a dynamic range of 93 dB with a power consumption of only 27.3 mW, enabling room-temperature, large dynamic range readout for MWIR HgCdTe detectors.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2025-03-25
  • 最后修改日期:2025-04-23
  • 录用日期:2025-05-08
  • 在线发布日期:
  • 出版日期:
文章二维码