单晶硅光伏电池片加热腔体温流场模拟与工艺优化
DOI:
CSTR:
作者:
作者单位:

江南大学 机械工程学院 江苏省食品先进制造装备技术重点实验室

作者简介:

通讯作者:

中图分类号:

基金项目:

中国国家自然科学基金(项目编号:12372078、 12372109),中国国家重点研发计划(2023YFB4605101),江苏省重点项目(省市联合)(BK20243044)


Thermal Flow Field Simulation and Process Optimization of Heating Chambers for Monocrystalline Silicon Photovoltaic Cells
Author:
Affiliation:

Jiangnan Key Laboratory of Advanced Food Manufacturing Equipment and Technology,Jiangnan University

Fund Project:

National Natural Science Foundation of China (Project Nos.: 12372078, 12372109)、National Key Research and Development Program of China (2023YFB4605101)、Jiangsu Provincial Key Project (Province-City Joint) (BK20243044)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    管式石英腔体始终作为光伏电池扩散制结工艺的核心装备,其腔体内部温度场与流场分布的均匀性直接影响单晶硅衬底表面磷原子的扩散动力学过程,从而影响了p–n结的界面形貌、结深一致性与掺杂浓度分布。因此,深入研究扩散腔体内部温度与流场的均匀性,对于提升单晶硅光伏电池的生产质量与效率具有重要意义。本文基于数值模拟与实验对比验证的方法,构建并确认了某单晶硅光伏电池加热腔体温流场的可靠性模型。在此基础上,系统分析了腔体额定工况下温流场分布规律。结果表明,尽管腔体内气体流场分布较为均匀,但满足工艺温度均匀性的有效空间仅占总长度的 65.92%。为进一步改善温度均匀性,本文针对腔体进气量和辅热电阻位置两个关键因素开展优化研究。优化结果表明,合理调节进气量和辅热电阻位置均能显著改善腔体内的温度均匀性,其中最佳工况下有效工艺空间利用率较原始条件提升约 20%—30%。

    Abstract:

    : As the core equipment for the diffusion junction formation process of photovoltaic (PV) cells, the tubular quartz chamber’s internal temperature and flow field uniformity directly affects the diffusion kinetics of phosphorus atoms on the monocrystalline silicon substrate surface. This further influences the interface morphology, junction depth consistency, and doping concentration distribution of the p-n junction. Therefore, in-depth research on the temperature and flow field uniformity inside the diffusion chamber is of great significance for improving the production quality and efficiency of monocrystalline silicon PV cells. This study established and validated a reliable model for the temperature and flow fields of a monocrystalline silicon PV cell heating chamber using numerical simulation and experimental comparison. Based on this model, the distribution law of temperature and flow fields under the chamber’s rated operating conditions was systematically analyzed. Results show that while the gas flow field inside the chamber is relatively uniform, the effective space meeting the process temperature uniformity requirement only accounts for 65.92% of the total length. To further improve temperature uniformity, optimization studies were conducted on two key factors: chamber air intake volume and auxiliary heating resistor position. Optimization results indicate that reasonable adjustment of both factors can significantly enhance the internal temperature uniformity. Under the optimal operating conditions, the utilization rate of the effective process space is increased by approximately 20%–30% compared to the original conditions.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2025-10-30
  • 最后修改日期:2025-11-12
  • 录用日期:2025-11-17
  • 在线发布日期:
  • 出版日期:
文章二维码