陶封光电耦合器灌胶技术研究
DOI:
CSTR:
作者:
作者单位:

中电44所

作者简介:

通讯作者:

中图分类号:

基金项目:


Research on Glue Filling Technology of Ceramic Sealed photocoupler
Author:
Affiliation:

Chongqing Optoelectronics Research Institute

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    陶封光电耦合器作为实现光电转换的核心元器件,由于尺寸小,需采用灌胶的方法增加绝缘性能,使其隔离电压满足要求。胶量少则绝缘性能增加有限,胶量多则影响器件密封封装,如何精确的进行胶量控制对产品的性能影响重大。文章研究了一种可有效控制胶量并有效消除气泡的灌胶工艺技术。采用45°斜针头从内瓷片中间倒角处进行灌胶的方式,使隔离电压从800V增加到1500V以上,提升了87.5%以上,解决了陶封光电耦合器隔离电压不满足要求的问题。通过热应力试验等对灌胶效果进行可靠性评价,证明采用的灌胶工艺技术可满足设计要求。该研究可为陶瓷器件密封腔体的灌胶工艺提供一种新思路。

    Abstract:

    As the core component of photoelectric conversion,ceramic sealed photocoupler needs to be filled with glue to increase the insulation performance and make it isolation voltage meet the requirements. Less glue content will limit the increase of the insulation performance, more glue content will affect the device sealing package, how to accurately control the glue content has a great impact on the performance of products. In this paper, a gluing technology which can effectively control the amount of glue and eliminate bubbles is studied. The 45°inclined needle is used for gluing from the chamfer in the middle of the inner porcelain plate to make the isolation voltage from 800V add to 1500V above, it is increased by more than 87.5%, and the problem that the isolation voltage of the ceramic photocoupler does not meet the requirements is solved. The reliability evaluation of gluing effect was carried out through thermal stress test, which proved that the gluing technology could meet the design requirements. This study can provide a new idea for the cementing process of ceramic device sealing cavity.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2025-11-12
  • 最后修改日期:2025-12-26
  • 录用日期:2026-01-04
  • 在线发布日期:
  • 出版日期:
文章二维码