液体辅助飞秒激光加工织构质量试验研究
DOI:
CSTR:
作者:
作者单位:

西安工业大学

作者简介:

通讯作者:

中图分类号:

基金项目:


Experimental Study on the Quality of Micro-Textures Fabricated by Liquid-Assisted Femtosecond Laser
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    钛合金的摩擦系数大、耐磨性差限制了其在航空航天领域的应用,在钛合金上加工表面微织构能够改善其摩擦学性能。为提高表面微织构的加工质量,探究液体辅助飞秒激光加工织构的质量,通过改变激光功率、扫描速度和扫描次数研究织构的尺寸和形貌的变化。结果表明:随着激光功率增加,织构深度和宽度显著增加;随着扫描速度的增加,织构深度和宽度减小;随着扫描次数的增加,织构深度增加,但扫描次数超过2时,织构宽度保持不变。在激光功率为2W、扫描速度为5mm/s、扫描次数为1时获得了最佳的表面微织构形貌。

    Abstract:

    The large friction coefficient and poor wear resistance of titanium alloys limit their applications in the aerospace field. Surface micro-textures processed on titanium alloys can improve their tribological properties. To enhance the machining quality of surface micro-textures, an investigation was conducted into the quality of micro-textures fabricated by liquid-assisted femtosecond laser processing. Variations in the dimensions and morphology of the textures were studied by adjusting laser power, scanning speed, and number of scans. The results indicate that the depth and width of the textures significantly increase with higher laser power, whereas they decrease with increased scanning speed. The depth of the textures increases with a greater number of scans, but the width remains unchanged when the number of scans exceeds two. The optimal surface micro-texture morphology was achieved at a laser power of 2?W, a scanning speed of 5?mm/s, and a single scan.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-01-30
  • 最后修改日期:2026-02-10
  • 录用日期:2026-03-03
  • 在线发布日期:
  • 出版日期:
文章二维码