原位热退火对1.8μm延伸波长InGaAs焦平面探测器关键性能的影响研究
DOI:
CSTR:
作者:
作者单位:

中国科学院上海技术物理研究所 红外探测全国重点实验室

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重点研发计划资助(2022YFB3904803);国家自然科学基金资助项目(62475272,62274169);上海市自然科学基金资助项目(22ZR1472600)


Effect of In-Situ Thermal Annealing on Key Performance of 1.8 μm Extended-Wavelength InGaAs Focal Plane Array Detectors
Author:
Affiliation:

National Key Laboratory of Infrared Detection Technologies, Shanghai Institute of Technical Physics, Chinese Academy of Sciences

Fund Project:

the National Key R&D Program Funded Projects, under Grant No. 2022YFB3904803, the National Natural Science Foundation of China, under Grant Nos. 62475272 and 62274169, the Natural Science Foundation of Shanghai, under Grant No. 22ZR1472600.

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    本文开展了1.8 μm延伸波长InGaAs材料与焦平面阵列 (FPA) 性能关联性研究,着重关注了材料原位退火这一在失配体系中常用的材料优化工艺对1.8 μm延伸波长InGaAs材料缺陷的作用。基于分子束外延技术生长的晶格失配的4英寸In0.57Ga0.43As材料,研究原位热退火处理对外延材料质量的影响。采用未退火与退火后的材料,研制了640×512平面型In0.57Ga0.43As探测器焦平面阵列。与基于未退火材料制备的FPA相比,采用700 ℃退火材料制备的FPA暗电流增大两倍,非均匀性、探测率、盲元率等指标均有不同程度的劣化,表明原位热退火处理并不适用于改善截止波长1.8 μm 低失配的In0.57Ga0.43As焦平面探测器阵列性能。在223 K下所制备的FPA实现了0.79 nA/cm2的低暗电流密度与2.7×1012 cm.Hz1/2.W-1的探测率,在实现波长延伸与高性能之间取得了良好平衡。

    Abstract:

    This study investigates the correlation between 1.8 μm extended-wavelength InGaAs material properties and the performance of focal plane arrays (FPAs), with a particular focus on the impact of in-situ annealing, which is a commonly used optimization technique in lattice-mismatched system. Using lattice-mismatched 4-inch In0.57Ga0.43As materials grown by molecular beam epitaxy (MBE), the influence of in-situ thermal annealing on the quality of the epitaxial material was examined. Both as-grown and annealed materials were used to fabricate 640×512 planar-type InGaAs detector FPAs. Compared to the FPA fabricated from as-grown material, the FPA based on material annealed at 700°C exhibited a twice increase in dark current, along with varying degrees of degradation in non-uniformity, detectivity, and defective pixel rate. These results indicate that in-situ thermal annealing is not suitable for improving the performance of low-mismatch In0.57Ga0.43As FPA detectors with a 1.8 μm cutoff wavelength. The fabricated FPA achieved a low dark current density of 0.79 nA/cm2 and a detectivity of 2.7×1012 cm.Hz1/2.W-1 at 223 K, demonstrating an excellent balance between wavelength extension and high performance.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-02-10
  • 最后修改日期:2026-03-13
  • 录用日期:2026-03-16
  • 在线发布日期:
  • 出版日期:
文章二维码