Abstract:Front illuminated Vis-NIR InGaAs single-element photodetectors offer advantages such as no need of flip-chip bonding, simplified packaging structure, and broad spectral response. To address the increase in dark current caused by elevated surface states and surface recombination after InP cap layer thinning process, the mechanism of p-type doping concentration, surface states, and the corresponding surface recombination velocity (SRV) on the sensitivity of devices were analyzed. While the cap layer thickness was reduced from 500 nm to 100 nm, the quantum efficiency at 0.7 μm increased from 6% to 41%, with the dark current density increasing from 0.2 to 16.7 nA/cm2. The SRV was found to significantly obviously affect device performance. As the SRV decreased from 3×103 cm/s to 1×103 cm/s, the peak specific detectivity (D*) improved from 2.31×1012 cm·Hz1/2·W?1 to 3.78×1012 cm·Hz1/2·W?1. By applying a surface passivation process, the measured dark current of the InGaAs detector was reduced, leading to an increase in peak D* from 2.6×1012 cm·Hz1/2·W?1 to 4.1×1012 cm·Hz1/2·W?1. The results demonstrate that improving surface passivation to lower the SRV is crucial for enhancing the performance of front-side illuminated visible-near infrared InGaAs detectors.