Abstract:This paper presents the design of a near-infrared (NIR)-enhanced silicon-based single-photon avalanche diode (SPAD) based on simulation software such as Silvaco and TFCalc. The design employs a planar reach through SPAD structure and achieves NIR enhancement through optimizations including antireflection coatings, absorption layer modifications, and active region doping distribution. A black silicon structure is utilized to improve NIR single-photon detection efficiency, while annealing and gettering processes are employed to repair damage, remove impurities, and reduce the dark count rate. The fabrication of the black silicon NIR-enhanced silicon single-photon detector is realized through a wet etching process using a mixed solution of nitric acid, hydrofluoric acid, phosphoric acid, and sulfuric acid. Test results demonstrate that the detector achieves a single-photon detection rate of 59.8% at 905nm and 13.1% at 1060nm. Compared to devices without the integrated black silicon NIR enhancement structure, the detection rates are improved by 42% at 905nm and 336% at 1060nm. The dark count rate of the black silicon detector is less than 500Hz at 263K and less than 2000Hz at 293K,comparable to conventional planar SPAD. Owing to its process compatibility, the NIR-enhanced technique presented in this paper has broad potential for application in various photodetectors, including SPAD, dTOF-CIS, and SPM, significantly improving device sensitivity.