基于激光参数与碳纳米管掺杂协同调控的LIG导电性能的研究
DOI:
CSTR:
作者:
作者单位:

北京信息科技大学

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(61771060);北京市教育委员会科研计划项目资助(KZ20231123221) ;北京市新世纪百千万人才工程培养资助项目(2019A20);现代测控技术教育部重点实验室资助(2024202101);北京信息科技大学北京市传感器重点实验室资助(2024202108)


Synergistic Modulation of Laser Parameters and Carbon Nanotube Doping for Enhanced Conductivity of Laser-Induced Graphene
Author:
Affiliation:

Beijing Information Science and Technology University

Fund Project:

The National Natural Science Foundation of China Grant (61771060); R&D Program of Beijing Municipal Education Commission(KZ20231123221);The Beijing New Century Hundred Million Talents Project Cultivation Grant (2019A20); The Key Laboratory of Modern Measurement and Control Technology, Ministry of Education Grant ( 2024202101); Supported by Beijing Key Laboratory of Sensors of Beijing Information Science and Technology University (2024202108)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    本研究针对激光诱导石墨烯(LIG)导电性能优化问题,系统探究了激光参数调控与多壁碳纳米管(MWCNTs)原位掺杂对LIG电阻特性及微观形貌的影响规律。实验结果表明:在5~10J/mm2能量密度范围内,LIG电阻值随激光能量密度增加显著降低,并在激光功率30W、能量密度8J/mm2条件下,所得LIG电阻值最低,达到约1kΩ;进一步采用MWCNTs与PAA不同质量比进行原位掺杂后,SEM表征显示复合LIG形成了更完善的协同导电网络,复合LIG电阻值按一定规律显著降低,最低可达0.5kΩ,性能优于纯LIG。基于此,本文提出了激光参数与掺杂协同调控的LIG导电性能优化窗口,为高性能柔性电阻式应变传感器的制备提供了有效的工艺优化策略。

    Abstract:

    This study investigates the optimization of the electrical conductivity of laser-induced graphene (LIG) by systematically analyzing the effects of laser parameters and in situ doping with multi-walled carbon nanotubes (MWCNTs) on the resistance characteristics and microstructure of LIG. The experimental results show that, within the energy density range of 5-10J/mm2, the resistance of LIG decreases with increasing laser energy density. The minimum resistance, approximately 1kΩ, is obtained at a laser power of 30W and an energy density of 8 J/mm2. After in situ doping with different mass ratios of MWCNTs to poly(amic acid) (PAA), scanning electron microscopy (SEM) shows that the composite LIG forms a more complete conductive network.As a result, the resistance of the composite LIG is further reduced to a minimum of 0.5kΩ, which is lower than that of pristine LIG.These findings indicate that an effective processing window for optimizing the conductivity of LIG can be established through the combined regulation of laser parameters and dopant content.This work provides a practical reference for the fabrication and performance optimization of LIG-based flexible resistive strain sensors.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-03-19
  • 最后修改日期:2026-04-27
  • 录用日期:2026-04-28
  • 在线发布日期:
  • 出版日期:
文章二维码