缓冲层厚度与层数对InP衬底上InGaAs材料的结构特性与光学性能的影响
DOI:
CSTR:
作者:
作者单位:

重庆光电技术研究所.重庆.400060

作者简介:

通讯作者:

中图分类号:

基金项目:


Effects of buffer layer thickness and number on structural properties and optical performance of InGaAs on InP
Author:
Affiliation:

Chong qing Optoelectronics Research Institute

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    文章系统研究了InP衬底上InGaAs缓冲层的厚度与层数,对2000 ppm晶格失配的In0.44Ga0.56As外延材料性能的调控规律。研究发现,在固定晶格失配度下,存在缓冲层厚度与层数的最优匹配关系,可实现高质量失配InGaAs材料的可控制备。实验结果表明,当缓冲层层数为6,单层层厚为200 nm时,外延材料的综合性能最优,其XRD半峰宽低至31.3 arcsec,本征载流子浓度低至5.5×1014 cm-3,核心指标与晶格匹配的In0.47Ga0.53As材料相当。研究进一步发现,缓冲层总厚度过厚或层数过多会引发晶格弛豫,造成晶体质量急剧退化,维持外延层应变状态是实现该类失配材料高质量生长的关键。该研究为高失配度III-V族半导体外延材料的结构设计与工艺优化提供了重要的实验依据。

    Abstract:

    In this work, we investigate the modulation law of the thickness and layer number of InGaAs buffer layers on the performance of In0.44Ga0.56As epitaxial materials with a 2000 ppm lattice mismatch grown on InP substrates. We demonstrate that, under a fixed lattice mismatch, there exists an optimal matching relationship between the thickness and layer number of the buffer layers, which enables the controllable growth of high-quality lattice-mismatched InGaAs materials. Experimental results show that the buffer structure with 6 layers and a single-layer thickness of 200 nm yields the optimal material performance, with a full width at half maximum (FWHM) of the X-ray diffraction (XRD) rocking curve as low as 31.3 arcsec and a minimum intrinsic carrier concentration of 5.5×1014 cm-3. These key metrics are comparable to those of lattice-matched InGaAs materials. It is confirmed that excessive total thickness or an excessive number of buffer layers will induce lattice relaxation, resulting in severe degradation of crystal quality. Maintaining the strain state of the epitaxial layer is the core critical factor for the high-quality growth of this type of lattice-mismatched materials. this study provides important experimental evidence for the structural design and process optimization of large mismatch III-V group semiconductor epitaxial materials.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-03-23
  • 最后修改日期:2026-03-23
  • 录用日期:2026-04-07
  • 在线发布日期:
  • 出版日期:
文章二维码