基于响应率校准的室温长波HgCdTe红外光导探测器模型修正与掺杂浓度影响分析
DOI:
CSTR:
作者:
作者单位:

中国科学院上海技术物理研究所

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重点研发计划项目


Model Correction and Doping Concentration Effect Analysis of Room-Temperature Long-Wavelength HgCdTe Photoconductive Infrared Detectors Based on Responsivity Calibration
Author:
Affiliation:

ShangHai Institute of Technical Physics Chinese Academy of Sciences

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对室温长波HgCdTe光导红外探测器掺杂浓度优化缺乏系统研究、且现有仿真参数难以准确表征实际器件性能的问题,本文建立了HgCdTe光导探测器数值模型,并提出基于实测响应率的模型校准方法。以已知组分与结构参数的长波器件为参考,通过变温响应率曲线对关键参数进行修正,在此基础上系统研究了不同掺杂浓度下器件响应率的温度演化规律。结果表明:随着掺杂浓度升高,器件响应率峰值逐渐降低,峰值温度整体向高温推移。其机理在于,低温下高掺杂增强SRH复合与离化杂质散射,抑制光生载流子积累与输运;高温下热激发载流子增多,俄歇复合占主导,导致响应率下降。仿真表明,面向室温及近室温工作,中等掺杂浓度可在导电能力、输运特性与复合损失之间取得较优平衡,其中在1×1017~2×1017 cm-3的掺杂范围具有更优综合性能。进一步结合实际器件的变温响应测试与二次离子质谱分析结果(Secondary Ion Mass Spectrometry, SIMS),验证了模型对掺杂水平判别的有效性。本文结果可为室温长波HgCdTe光导探测器的模型修正与掺杂优化设计提供参考。

    Abstract:

    To address the lack of systematic studies on doping optimization in room-temperature long-wavelength HgCdTe photoconductive infrared detectors, and the difficulty of using existing simulation parameters to accurately describe real device performance, this work establishes a numerical model for HgCdTe photo-conductive detectors and proposes a calibration method based on measured responsivity. A long-wavelength device with known composition and structural parameters is used as the reference. The key model parameters are corrected using temperature-dependent responsivity curves. Based on the calibrated model, the temperature dependence of detector responsivity is systematically studied at different doping concentrations. The results show that, as the doping concentration increases, the peak responsivity gradually decreases. Meanwhile, the temperature corresponding to the peak responsivity shifts to higher values. This trend is governed by different mechanisms at different temperatures. At low temperatures, heavy doping enhances Shockley–Read–Hall (SRH) recombination and ionized impurity scattering. This sup-presses the accumulation and transport of photogenerated carriers. At high temperatures, the concentration of thermally generated carriers increases, and Auger recombination becomes dominant. As a result, the responsivity decreases.The simulations indicate that, for room-temperature and near-room-temperature operation, a moderate doping concentration offers a better balance among conductivity, carrier transport, and recombination loss. The optimal overall performance is obtained at doping concentrations of 1×1017 cm?3 to 2×1017 cm?3. The effectiveness of the model in identifying doping levels is further validated by combining temperature-dependent responsivity measurements from practical devices with secondary ion mass spectrometry (SIMS) results. These findings provide useful guidance for model calibration and doping optimization of room-temperature long-wavelength HgCdTe photoconductive infrared detectors.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-04-21
  • 最后修改日期:2026-06-17
  • 录用日期:2026-06-17
  • 在线发布日期:
  • 出版日期:
文章二维码