基于蓝宝石下转换的紫外能量传感器研制与性能表征
CSTR:
作者:
作者单位:

(1.重庆光电技术研究所,重庆 400060;2.四川压电与声光技术研究所,重庆 400060)

作者简介:

黄建(1984—),男,博士,工程师,主要从事光电探测器研究。

通讯作者:

中图分类号:

TN23

基金项目:


Development and Characterization of Ultraviolet Energy Sensor Based on Sapphire Down-Conversion
Author:
Affiliation:

(1. Chongqing Optoelectronics Research Institute,Chongqing 400060;2. Sichuan Institute of Piezoelectric and Acousto-Optic Technology,Chongqing 400060)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    紫外能量传感器是光刻机中监测曝光光源能量的关键零部件。文章基于荧光下转换技术路线,研制了由蓝宝石晶体、光电二极管、信号处理电路、滤光片、机械结构件等组成的紫外能量传感器;采用光学非共轴空间布局,实现多界面光热能量耗散,提高传感器工作稳定性、抗激光损伤能力;提出基于仿真预测的晶体多自由度互相补偿安装方法,提高响应均匀性;采用近红外增强光电二极管,两级放大、差分输出的电路结构,提高传感器重复性。通过相关双光路对比法,减小光源能量波动对测试结果的影响,完成传感器相关性能参数高精度测试表征;测试结果显示,在波长为 193 nm、脉宽为 10 ns、能量为 10 mJ、重频为 1 000 Hz的条件下,其重复性小于 0. 08%、非线性度达到 0. 018%、响应频率达到 13. 9 kHz、不稳定性达到 0. 005%、非均匀性达到 0. 23%/mm、抗强光损伤能力大于 1. 5×107个脉冲,可应用于相关光刻机曝光能量实时监测。

    Abstract:

    Ultraviolet energy sensors are key components for monitoring exposure light source intensity in lithography machines. Based on fluorescence down-conversion,herein we developed an ultraviolet energy sensor composed of a sapphire crystal,a photodiode,a signal-processing circuit,an optical filter,and mechanical structural components. A non-coaxial optical configuration was adopted to achieve multi-interface photothermal energy dissipation,improving both operational stability and laser-induced damage resistance. To enhance response uniformity, a multi-degree-of-freedom mutual compensation installation method based on simulation predictions was proposed. A near-infrared enhanced photodiode,a two-stage amplification,and a differential output circuit structure were adopted to improve the sensor′s repeatability. Furthermore,a dual-path correlation comparison method was used to mitigate the impact of source energy fluctuations, enabling high-precision testing and characterization of sensor performance. The test results show that the repeatability was less than 0. 08%,nonlinearity was 0. 018%,response frequency reached 13. 9 kHz,instability reached 0. 005%,non-uniformity reached 0. 23%/mm, and resistance to intense light damage exceeded 1. 5×107 pulses, demonstrating its viability for real-time exposure energy monitoring in lithography machines.

    参考文献
    相似文献
    引证文献
引用本文

黄建,曹飞,唐遵烈,陈彤,屈菁菁,张兴,袁,中朝,丁,雨憧,甘,秋宏,陈,于伟.基于蓝宝石下转换的紫外能量传感器研制与性能表征[J].半导体光电,2026,47(5):886-893. HUANG Jian, CAO Fei, TANG Zunlie, CHEN Tong, QU Jingjing, ZHANG Xing, YUAN Zhongchao, DING Yuchong, GAN Qiuhong, CHEN Yuwei. Development and Characterization of Ultraviolet Energy Sensor Based on Sapphire Down-Conversion[J].,2026,47(5):886-893.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-07-21
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2026-10-23
  • 出版日期:
文章二维码