磁控溅射氮化硅薄膜及微环谐振器的超高真空退火
CSTR:
作者:
作者单位:

(上海大学微电子学院,上海 201800)

作者简介:

李永彬(2001—),男,硕士研究生,主要研究方向为磁控溅射制备氮化硅薄膜及其退火工艺;董渊(1990—),男,博士,教授,主要研究方向为应用于光通信、光传感、光计算的集成光电子器件设计与制造工艺。

通讯作者:

中图分类号:

TN256

基金项目:

国家重点研发计划项目(2024YFA1209100);国家自然科学基金项目(62575166);传感器技术全国重点实验室基金项目(SKT2510);上海市科研计划项目(25TS1410400,24JD1401800);上海市汽车智能网联交互芯片与系统重点实验室项目 .


Ultra-High Vacuum Annealing of Magnetron-Sputtered Silicon Nitride Films and Microresonators
Author:
Affiliation:

(School of Microelectronics,Shanghai University,Shanghai 201800,CHN)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    室温磁控溅射制备的氮化硅(SiN)薄膜具有低氢含量和低温工艺兼容性等优势,但仍需通过后退火处理降低由结构缺陷引起的光散射损耗。文章系统研究了超高真空(UHV)退火对室温溅射 SiN薄膜及微环谐振器性能的影响。采用 X射线光电子能谱、傅里叶变换红外光谱、原子力显微镜、椭圆偏振光谱仪及透射谱测试表征 400℃,600℃,800℃退火后薄膜成分、化学键合状态、表面形貌、折射率以及器件本征品质因子(Qi)与传播损耗。结果表明:400℃退火后器件性能最佳,Qi由 2. 9×104提升至 3. 4×104,传播损耗由 9. 6 dB/cm降至 8. 1 dB/cm;继续升高退火温度,器件性能明显下降,800℃时虽有所恢复,但仍低于未退火水平。该研究表明,适度 UHV退火可有效改善室温溅射 SiN微环谐振器性能,而过高温退火则导致性能退化。

    Abstract:

    Silicon nitride(SiN)films deposited by room-temperature magnetron sputtering offer low hydrogen content and compatibility with low-temperature processing;however,post-annealing is still required to reduce the optical scattering loss caused by structural defects. Here,we systematically investigate the effects of ultra-high vacuum(UHV)annealing on room-temperature sputtered SiN films and microresonators. The material properties, including film composition, bonding configuration, surface morphology,and refractive index were characterized using X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy,atomic force microscopy,and ellipsometry after annealing at 400℃,600℃,and 800℃. Optical transmission measurements quantified the device’s intrinsic quality factor(Qi)and propagation loss. The results indicated that the device performance peaked after 400℃ annealing,with Qi increasing from 2. 9×104 to 3. 4×104 and propagation loss dropping from 9. 6 to 8. 1 dB/cm. Higher annealing temperatures degraded performance significantly;despite partial recovery at 800℃,it remained inferior to the as-deposited device. These results indicate that moderate UHV annealing can effectively improve the performance of room-temperature-sputtered SiN microring resonators,whereas annealing at excessively high temperatures leads to performance degradation.

    参考文献
    相似文献
    引证文献
引用本文

李永彬,闫文韬,杨槟榔,曹芳成,郑少南,邱阳,赵兴岩,钟其泽,董渊,胡挺.磁控溅射氮化硅薄膜及微环谐振器的超高真空退火[J].半导体光电,2026,47(5):938-944. LI Yongbin, YAN Wentao, YANG Binglang, CAO Fangcheng, ZHENG Shaonan, QIU Yang, ZHAO Xingyan, ZHONG Qize, DONG Yuan, HU Ting. Ultra-High Vacuum Annealing of Magnetron-Sputtered Silicon Nitride Films and Microresonators[J].,2026,47(5):938-944.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-04-19
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2026-10-23
  • 出版日期:
文章二维码