基于有限元分析的光纤不规则宏弯损耗计算方法与夹角优化
CSTR:
作者:
作者单位:

(1.华北电力大学电气与电子工程学院,河北保定 071003;2.华北电力大学河北省电力物联网技术重点实验室,河北保定 071003;3.国网福建省电力有限公司,福州 350001;4.国网福建省电力有限公司电力科学研究院,福州 350007)

作者简介:

赵丽娟(1981—),女,博士,教授,主要从事光纤传感与光纤通信方面的研究;徐志钮(1979—),男,博士,教授,主要从事分布式光纤传感器及其在电气设备状态监测和故障诊断应用方面的研究。

通讯作者:

中图分类号:

TN253

基金项目:

国家自然科学基金项目(62171185,62273146);河北省省级科技计划资助项目(SZX2020034).


Finite Element Calculation of Irregular Macrobending Loss in Optical Fibers and Optimization of the Fixture Angle
Author:
Affiliation:

(1. School of Electrical and Electronic Engineering,North China Electric Power University,Baoding 071003,CHN; 2. Hebei Key Laboratory of Power Internet of Things Technology,North China Electric Power University,Baoding 071003,CHN;3. State Grid Fujian Electric Power Co.,Ltd.,Fuzhou 350001,CHN;4. State Grid Fujian Electric Power Co.,Ltd.,Electric Power Research Institute,Fuzhou 350007,CHN)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对光纤网络非侵入式光功率测量中不规则弯曲损耗难以定量计算的问题,提出了一种基于有限元分析的光纤不规则宏弯损耗计算方法。为验证该方法的有效性,基于 COMSOL中的波束包络法模块构建了某典型夹具约束下光纤的不规则弯曲模型,引入 S参数实现了宏弯损耗的量化计算,采用 3D打印技术制作该典型夹具并搭建实验系统进行了验证。结果表明,该典型夹具的有限元计算损耗为 1. 15 dB,实验测得的平均损耗为 1. 44 dB,二者基本吻合。在此基础上,对典型夹具夹角在 70°~120°范围内变化时夹角对弯曲损耗的影响进行了研究,结果表明,光纤宏弯损耗随夹具夹角的增大呈现出先增大后减小的趋势,当夹具夹角在 85°~95°的范围内变化时,产生的泄漏光功率既能满足光电探测器的响应需求,又能使主干光纤链路的损耗处于 1~3 dB的安全允许阈值范围内。该研究为不规则弯曲场景下泄漏光功率的计算提供了一种可靠方法,并为典型夹具下泄漏比例和最佳夹角范围的确定提供参考。

    Abstract:

    Irregular macrobending loss is difficult to quantify in non-intrusive optical power measurements of optical fiber networks. To address this problem,a finite element method for calculating irregular macrobending loss is proposed. To validate the proposed method,an irregularly bent fiber model constrained by a representative fixture was developed using the electromagnetic waves,the beam envelopes interface in COMSOL Multiphysics. S-parameters were used to quantify the macrobending loss. The fixture was then fabricated by 3D printing,and an experimental setup was established to validate the proposed method. The results show that the loss calculated by the finite element analysis for the representative fixture is 1. 15 dB. This value is in reasonable agreement with the experimentally measured average loss of 1. 44 dB. On this basis,the effect of the fixture angle on bending loss was investigated over an angular range of 70° to 120°. The macrobending loss first increased and then decreased as the fixture angle increased. When the fixture angle was between 85° and 95°,the leaked optical power was sufficient to meet the response requirements of the photodetector,while the loss of the backbone fiber link remained within the allowable safety range of 1~3 dB. This study provides a reliable method for calculating macrobending loss under irregular fiber-bending conditions. Moreover,it provides a useful reference for determining the leakage ratio and the optimal fixture angle range in non-intrusive optical power measurements.

    参考文献
    相似文献
    引证文献
引用本文

赵丽娟,侯海舰,杨曜齐,徐志钮,姬睿杰,袁豪,陈锦山,王新澜,吴诗雨.基于有限元分析的光纤不规则宏弯损耗计算方法与夹角优化[J].半导体光电,2026,47(5):945-952. ZHAO Lijuan, HOU Haijian, YANG Yaoqi, XU Zhiniu, JI Ruijie, YUAN Hao, CHEN Jinshan, WANG Xinlan, WU Shiyu. Finite Element Calculation of Irregular Macrobending Loss in Optical Fibers and Optimization of the Fixture Angle[J].,2026,47(5):945-952.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-08-24
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2026-10-23
  • 出版日期:
文章二维码