Abstract:Optical phased arrays (OPAs) must simultaneously achieve a narrow divergence angle, a wide lateral scanning field of view (FOV), and effective grating lobe suppression to meet the requirements of high-performance LiDAR systems. However, attaining all three objectives under relaxed fabrication tolerances—particularly while maintaining compatibility with mature deep ultraviolet (DUV) lithography—remains a major challenge. This work proposes a novel OPA architecture that combines gap-modulated weak coupling with a genetic algorithm (GA)-optimized non-uniform waveguide array. By reducing the waveguide pitch to 3 μm and employing a GA to optimize the lateral positions of 128 radiating elements, the design realizes effective grating lobe suppression across a ±90° lateral scanning range with a side-mode suppression ratio (SMSR) of 13 dB, corresponding to a total scan angle of approximately 180°. The wavelength tuning range is simultaneously extended from 60 nm (1500 nm-1560 nm) to 100 nm (1500 nm-1600 nm), exhibiting a tuning efficiency of 0.10 °/nm. All critical dimensions remain ≥200 nm, ensuring full compatibility with 248 nm DUV lithography. This design overcomes the conventional trade-off among large effective aperture, wide field of view, and fabrication complexity, offering a scalable, high-performance, and low-cost solution for integrated LiDAR transmitters.