Abstract:This paper proposes an on-chip integrated acousto-optic modulator based on a scandium-doped aluminum nitride (AlScN) piezoelectric thin film and a silicon nitride (Si?N?) spiral waveguide. The device employs a single-phase unidirectional transducer (SPUDT) to excite directional surface acoustic waves in AlScN film to improve the utilization efficiency of acoustic wave energy in the target propagation direction. At the same time, by exploiting the low-loss transmission characteristic of the Si?N? waveguide, a spiral structure is used to increase the interaction length so as to enhance the modulation efficiency. Simulations were conducted to analyze the influence of acoustic wavelength, AlScN piezoelectric layer thickness, SiO? upper cladding thickness, and the spacing between the waveguide and the electrode on the acousto-optic overlap factor. At a Si?N? waveguide width of 1.4 μm and height of 300 nm, the waveguide supports single quasi-TE mode transmission at 1550 nm. Under conditions of an acoustic wavelength of 1.6 μm, AlScN piezoelectric layer thickness of 900 nm, SiO? upper cladding thickness of 2.55 μm, and waveguide-electrode spacing of 12 μm, the device achieves a large acousto-optic overlap factor at approximately 3.074 GHz.