锗硅光电探测器的增益峰值电极设计与联合仿真
DOI:
CSTR:
作者:
作者单位:

上海大学 微电子学院

作者简介:

通讯作者:

中图分类号:

基金项目:

国家重点研发计划项目(2024YFA1209100); 上海市汽车智能网联交互芯片与系统重点实验室项目;传感器技术全国重点实验室(SKT2510);上海市科研计划项目(25TS1410400、24JD1401800);国家自然科学(62575166).


Design and Co-Simulation of Gain-Peaking Electrodes for Germanium-on-Silicon Photodetectors
Author:
Affiliation:

Shanghai University, School of Microelectronics

Fund Project:

National Key R&D Program of China (2024YFA1209100); Shanghai Key Laboratory of Intelligent Connected Vehicle Interaction Chips and Systems; National Key Laboratory of Sensor Technology (SKT2510); Shanghai Municipal Science and Technology Research Project (25TS1410400, 24JD1401800); National Natural Science Foundation of China (62575166).

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    锗硅光电探测器是硅基光电子集成平台中大容量数据通信的核心器件,但其带宽易受内部寄生参数和外部电极高频效应限制。本文基于电感增益峰值技术,在绝缘体上硅(SOI)平台上设计单层螺旋电感电极,并建立光电探测器—电极联合仿真模型。采用电磁仿真分析螺旋和焊盘尺寸对电极性能影响,建立考虑RC时间常数和载流子渡越时间的等效电路模型,通过器件仿真提取参数,并接入电极S参数模块。仿真结果表明,增大螺旋尺寸可提高等效电感;减小焊盘尺寸可降低寄生电容和插入损耗;3-dB带宽随电感增大先升高后降低,在电感约为305 pH时由约42 GHz提升至约67 GHz。研究结果可为增益峰值电极与光电探测器的协同设计提供参考。

    Abstract:

    Germanium-on-silicon photodetectors are key components of silicon photonic integrated platforms for high-capacity data communications. However, their bandwidth is limited by intrinsic parasitics and the high-frequency effects of external electrodes. Based on inductive gain peaking, a single-layer spiral-inductor electrode was designed on a silicon-on-insulator (SOI) platform, and a joint photodetector–electrode simulation model was established. Electromagnetic simulations were performed to analyze the effects of the spiral and pad dimensions on the electrode performance. A small-signal model including RC time constant and carrier transit time was developed. Its parameters were extracted from device simulations, and a two-port S-parameter module of the electrode was incorporated into the model. The simulation results show that increasing the spiral dimensions increases the equivalent inductance, while reducing the pad dimensions decreases the parasitic capacitance and insertion loss. The 3-dB bandwidth first increases and then decreases with increasing inductance. At an inductance of approximately 305 pH, the 3-dB bandwidth increases from approximately 42 GHz to 67 GHz. These results provide guidance for the co-design of gain-peaking electrodes and photodetectors.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-07-23
  • 最后修改日期:2026-07-23
  • 录用日期:2026-08-05
  • 在线发布日期:
  • 出版日期:
文章二维码