Abstract:Aiming at the stress challenge induced by lattice and thermal mismatch between silicon substrate and GaN, this paper regulates the external stress of Si-substrate GaN-based green LEDs via bonding metal structural design and continuous stepwise annealing process. High-resolution X-ray diffraction (HRXRD) and electroluminescence (EL) spectroscopy are adopted to systematically investigate the influence of stress evolution on the optoelectronic performance of devices. The results show that when the annealing temperature rises from room temperature to 200 °C, the in-plane tensile strain of GaN film decreases from 0.0941% to 0.042%, and the out-of-plane compressive strain changes from-0.031% to -0.0178%. The lattice constants gradually approach the stress-free state. Synchronous EL measurements reveal that the optical power of the device continuously declines compared with the initial state (176 mW before annealing). The emission wavelength presents a redshift of approximately 12 nm, and the full width at half maximum (FWHM) broadens from 28 nm to 35 nm. Analysis on the stress modulation mechanism verifies that the annealing-induced increase of compressive stress in InGaN quantum wells aggravates the quantum-confined Stark effect (QCSE), reduces the probability of electron-hole radiative recombination, and ultimately leads to the degradation of luminous efficiency.