热退火对射频磁控溅射SiC基AlN薄膜结构与性能的影响
DOI:
CSTR:
作者:
作者单位:

1.北京科技大学;2.半导体研究所;3.湖南理工大学

作者简介:

通讯作者:

中图分类号:

TN04

基金项目:

国家自然科学基金(资助号:52002021、62474018、62304077)、北京市自然科学基金(资助号:4262084)、湖南省自然科学基金区域联合基金(资助号:2026JJ80239)


Effects of thermal annealing on the structure and properties of AlN films on SiC substrates deposited by RF magnetron sputtering
Author:
Affiliation:

1.University of Science and Technology Beijing;2.Institute of Semiconductors;3.Hunan Institute of Science and Technology

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    AlN禁带宽度大、介电常数高,且与4H-SiC晶格失配小,是SiC基MOS器件栅介质的理想候选材料,但磁控溅射制备的AlN薄膜致密度较低,氧杂质与缺陷较多,制约其介电性能与可靠性。为此,采用射频磁控溅射法直接在4H-SiC衬底上沉积AlN薄膜并于氮气气氛中进行热退火处理。在系统表征退火前后薄膜成分、结构与界面性能的基础上,利用X射线反射率定量给出了退火引起的薄膜密度变化,并通过Ni/AlN/4H-SiC/Ni MIS电容的漏电流-电压(I-V)测试对薄膜绝缘性能的改善进行了电学验证。结果表明,退火后孔隙收缩、缺陷减少,薄膜密度由3.05 g/cm³增至3.15 g/cm³,632 nm波长处的折射率由1.96提高至1.99,且薄膜呈c轴择优取向,AlN/SiC界面平整光滑;随退火温度升高,N—O杂质键减少,Al—N键合强度增强,成键环境明显改善。Ni/AlN/4H-SiC/Ni MIS电容在+5 V偏压下的漏电流经退火后由6.5×10?? A降至2.3×10?? A。可见,热退火能有效改善AlN薄膜的致密度与键合质量,提升其绝缘性能,为高性能SiC功率器件栅介质的制备提供了实验依据。

    Abstract:

    Abstract:Aluminum nitride (AlN) is an ideal candidate as the gate dielectric for SiC-based MOS devices due to its wide bandgap, high dielectric constant, and small lattice mismatch with 4H-SiC. However, AlN films prepared by magnetron sputtering generally suffer from low density, as well as abundant oxygen impurities and defects, which severely limit their dielectric performance and reliability. In this work, AlN thin films were deposited directly on 4H-SiC substrates by radio frequency (RF) magnetron sputtering followed by thermal annealing in N? ambient. In addition to the systematic characterization of the annealing effects on the composition, structure, and interfacial properties of the films, the annealing-induced density variation was quantitatively determined by X-ray reflectivity, and the improvement in insulating performance was electrically verified by current-voltage (I-V) measurements on Ni/AlN/4H-SiC/Ni MIS capacitors. The results show that after annealing, the pores shrink and the defects are reduced; the film density increases from 3.05 g/cm³ to 3.15 g/cm³, and the refractive index at a wavelength of 632 nm rises from 1.96 to 1.99. Moreover, the films exhibit a c-axis preferred orientation, and the AlN/SiC interface is flat and smooth. With increasing annealing temperature, the N—O impurity bonds decrease while the Al—N bonding strength is enhanced, indicating a significantly improved bonding environment. The leakage current of the Ni/AlN/4H-SiC/Ni MIS capacitors at +5 V bias decreases from 6.5×10?? A to 2.3×10?? A after annealing. These results demonstrate that thermal annealing can effectively improve the densification and bonding quality of AlN thin films, enhancing their insulating performance, providing an experimental basis for the fabrication of gate dielectrics for high-performance SiC power devices.

    参考文献
    相似文献
    引证文献
引用本文
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-08-24
  • 最后修改日期:2026-10-08
  • 录用日期:2026-10-09
  • 在线发布日期:
  • 出版日期:
文章二维码